The current consumption of the amplifier is used to heat the capsules, which makes it possible to use the MC50 in extreme climate conditions, like very high humidity, or temperatures of down to – 30 degrees!
The MC 50 is the ultimate microphone for the recording of stereophonic and multichannel surround formats!
The MC50-Quad has a transformerless circuit design, with no electrolytic capacitors in the audio path. The impedance circuitry is comprised of matched ultra-low-noise transistors, film capacitors, and “military grade” resistors. The microphone has four separate circuits, one for each capsule diaphragm.
In Double MS-Mode the microphone has to be slightly turned, that the upper capsule (Out-2) will directly face the main sound-source.
No matter if you are using the MC50 as a mono, or as a stereo microphone you can always fine-adjust mic-patterns to make sure that they fit your exact needs – from omnidirectional to wide cardioid to figure-8 to super-cardioid with any step in between. You can remote-control your microphone-patterns with your mixing desk!
The Nevaton MC50 microphone comes in a fine hardwood-box.
A three meter long four channel XLR-break-out cable is part of the set.
Optional a special cable for Double MS is available.
Directional_pattern | Blumlein stereo, EVERYTHING IN-BETWEEN, Mid-side stereo, Mono, Quad &,amp, XY stereo |
Acoustic operating principle | Pressure gradient transducer |
Frequency range | 20 - 20.000 Hz |
Sensitivity | 20 mV/Pa |
Rated impedance | 50 ohms |
Rated load impedance | 1000 ohms |
Equivalent noise level (A-weighted) | 4 dB-A |
Signal-to-noise (A-weighted) | 138 dB |
Max SPL (THD<0.5%)@ 1kHz: | 142 dB |
Supply voltage | 48V ( /- 4V) |
Current consumption | 7.5 mA |
Matching connector | 10-pin XLR-type, to 4x 3-pin XLR standard |
Weight output stage | 536 g |
Diameter | body: 30mm, head: 51mm |
Length | 237 mm |
Switchable options Pad | -10dB switch, under the mic-body, which can be easily removed to access the switch |
Available Colours | brass with a dark-grey non-reflective paint finish |
Switchable options Filter/EQ | (70Hz), low-cut filter (linear, under the mic-body, which can be easily removed to access the switche |